Full private-side replacement
Lead or galvanized-requiring-replacement service line replaced in full from the main connection through the private path to the building meter - not a partial patch sold as a complete cure.
RemodelingRenovation Co.
WATER MAIN REPLACEMENT
Lead service line replacement for Chicago homes and buildings built before 1986
Coordinated residential services
When Chicago homeowners search for water main replacement, they usually need the private water service line that runs from the city main (and buffalo box) into the building - especially when that line is lead or galvanized requiring replacement. The city owns the main under the street; the service line brings water to your meter.
URB plans full lead service line replacement as infrastructure scope: confirm material, obtain permits, excavate the path, replace the line with copper sized for the building, reconnect meter and B-box components as required, pressure-test, restore the trench, and leave the work area clean. This is not emergency plumber dispatch for a street main break.
Chicago still has a large inventory of lead service lines - on the order of roughly 400,000 buildings - concentrated in older housing stock, especially pre-1986 houses and two-flats. Lead service lines raise health and property concerns that belong in planning conversations before interior remodel work covers or depends on the supply path.
URB is a remodeling and renovation contractor that coordinates licensed replacement from the main connection through the private side, including copper installation, meter and buffalo-box coordination, and City permit/inspection sequencing. We help owners understand owner-initiated LSLR and related City programs without inventing fee-waiver eligibility, Equity LSLR contractor status, or cost ranges that were not quoted for the address.
This page is Chicago-weighted. Standalone service-line replacement and remodel-paired work (kitchen, bath, or whole-home when floors open or shutoffs upgrade) are both in scope when the property and logistics fit. Condo and multi-unit buildings may require management or board coordination and phased shutoffs.
Company credentials
URB Remodeling & Renovation Co. treats Chicago water main / lead service line replacement as planned excavation and plumbing construction: confirm material, permit, replace with copper, test, restore the trench, and document closeout - not a same-day emergency main-break response and not a claim that URB is the City Department of Water Management.
The city water main sits under the street. The service line runs from that main (via the buffalo box / curb stop) into your building to the meter. Searches for "Chicago water main replacement" usually mean full private service line replacement when lead is present.
Use the City of Chicago lead service line inventory at sli.chicagowaterquality.org as a self-check, then confirm material on site before locking scope. Inventory data is a planning aid, not a substitute for field verification.
Owner-initiated LSLR, equity programs, and permit fee waivers can exist and eligibility changes. URB helps navigate documentation and permits; we do not invent savings numbers or claim free Equity LSLR work unless URB is that program contractor for your address. Some City waivers exclude combo with home renovation - remodel clients should confirm before assuming a waiver stacks with a kitchen or bath project.
Service line work often pairs with kitchen, bathroom, or whole-home remodeling when floors open, meters move, or shutoffs upgrade. Standalone LSLR stays available when the interior remodel is separate.
Scope & details
NOTE - Homeowners often say "water main"; this scope is the private service line from the city main into the building (Chicago still has a large inventory of lead service lines, especially pre-1986 stock). Interior repiping beyond the meter, whole-building plumbing upgrades, and landscaping upgrades beyond trench restore are not included unless separately quoted. Condo / multi-unit buildings may require management / board coordination and phased shutoffs.
Lead or galvanized-requiring-replacement service line replaced in full from the main connection through the private path to the building meter - not a partial patch sold as a complete cure.
New copper water service sized per code and demand (typical 1 inch or as required by meter and load), coordinated with existing meter conditions.
Buffalo box (B-box), curb stop, and meter couplings replaced or reconnected as required for a complete, code-compliant service.
City of Chicago permits and inspection points identified during planning, with responsibility clarified before excavation begins.
New line pressure-tested; water service restored; flow and leak-free operation verified at meter and fixtures before closeout.
Parkway, sidewalk, driveway, and landscaping disturbed by excavation restored to match existing conditions as closely as practical.
Plan beforePlanning priorities
A meaningful scope is specific to the property. Existing construction, applicable permits and inspections, material lead times, access, occupancy, and connected finish work can all influence the correct approach.
Inventory lookups help; field confirmation of lead, galvanized, or mixed material from B-box to meter sets the real scope.
URB scopes private service line replacement. Active street main breaks and Department of Water Management emergency response are a different path.
If a kitchen, bath, or whole-home project will open floors or change shutoffs, coordinate service line timing so finished work is not torn open later. Confirm whether any City fee waiver excludes renovation combos.
City review
Water service replacement in Chicago typically requires City permits and inspections. During planning, URB identifies likely permit and inspection points for the address and states who files what before mobilization. This overview is not legal or municipal advice; requirements are confirmed for the actual property and scope.
Owner-initiated lead service line replacement programs, equity programs, and permit fee waivers can apply in some cases, and eligibility changes over time. URB helps owners navigate documentation and City coordination. We do not invent savings figures, claim free Equity LSLR work unless URB is that program contractor for the address, or promise DWM/311 emergency main-break response. Some City waivers exclude combination with home renovation - ask before assuming a remodel and a waiver stack.
Official inventory self-check: sli.chicagowaterquality.org. Broader Chicago property and permit context sits on the Chicago remodeling page.
Building path
Condo and multi-unit buildings may share shutoffs, require management or board notice, phased water outages, and protection of common areas during excavation or interior meter access. URB plans those logistics with the building path rather than treating the unit like a detached house. Interior building plumbing beyond the meter remains separately scoped.
For occupied high-rise interior renovations that meet the service line work, see also condo and high-rise remodeling.
A managed renovation
We begin with what is not working, the desired result, known property conditions, timing, and investment range.
Scope, responsibilities, existing conditions, approvals, selections, logistics, and the construction sequence come into focus.
A project manager coordinates trades, materials, protection, progress, communication, and finish quality.
We review the work with the homeowner, address final items, and close the project with a clear walkthrough.
Selected URB work
The most successful remodeling projects hold together at every scale—from the overall layout and daily function to alignments, transitions, protection, communication, and the quiet details that make a finished space feel resolved.
“The estimate was detailed and fair, there were no surprises, and the team kept us informed throughout the process.”
Garrett F. Verified client review



Good questions, clear answers
Most Chicago homeowners who say "lead water main" mean the private service line from the city main into the building. The city owns the main under the street; lead concerns for homes and two-flats are usually on that private service line, especially in pre-1986 stock. URB confirms material from the buffalo box path to the meter before defining replacement scope.
Start with the City of Chicago lead service line inventory at sli.chicagowaterquality.org, then confirm on site. Inventory status is a planning aid; field verification sets the construction scope.
City water main work is municipal infrastructure under the street. Private replacement is the service line from the main / B-box into your building to the meter - copper installation, meter couplings, trench restore, and related permits. URB scopes the private side; emergency street main breaks belong with the City / DWM path, not this page.
Duration depends on length and depth of the run, surface restoration (parkway, sidewalk, driveway), permit and inspection timing, access, and whether work is standalone or paired with a remodel. After pressure testing and backfill, disturbed parkway / sidewalk / driveway / landscaping is restored to match existing conditions as closely as practical - not as a full landscape redesign unless separately quoted.
Yes, when floors open, meters move, or shutoffs upgrade, coordinating service line replacement with kitchen, bathroom, or whole-home work can avoid tearing finished areas later. Confirm whether any City fee waiver excludes renovation combinations before assuming both stack. Standalone LSLR remains available when the interior remodel is separate. Start the conversation on Contact.
Let’s talk about your home
Tell us what you want to change, what is not working, and where you need guidance. We’ll help you understand the right next step. Call (847) 410-2691 or visit 4751 W Touhy Ave, Unit 101, Lincolnwood.
Schedule your consultation